HP Laserjet P3015 50 Fuser Error
Information:
The HP Laserjet P3015 50 Fuser Error - Displayed on Control Panel
50.1 Fuser Error – Low Fuser temperature reading detected from thermistor (TH1)
50.2 Fuser Error – Fuser Warm up error, unable to reach and maintain specific temperature.
50.3 Fuser Error - Fuser temperature exceeds allowed temperature at Thermistor (TH1)
50.4 Fuser Error – Drive Circuit failure. Defective fuser assembly
50.8 Fuser Error - Low Fuser temperature reading detected from thermistor (TH2)
50.9 Fuser Error - Fuser temperature exceeds allowed temperature at Thermistor (TH2)
Recommended Remedies
- Power down the HP Laserjet P3015 and wait 30 seconds.
and power up the HP Laserjet Printer to decide whether or not the error is chronic. - Determine that the correct fuser is installed in the HP Laserjet P3015.
- Make sure that the correct voltage fusing assembly is installed in the HP Laserjet P3010/ P3015 Printer.
50.2 Fuser Error
Confirm that the Connecting adapter J8002 and J1505 are seated correctly on the Engine Control Unit (ECU) and connecting adapter J18 is seated correctly on the fuser assembly.
50.1 Fuser Error
50.3 Fuser Error
50.4 Fuser Error
50.8 Fuser Error
50.9 Fuser Error
- Confirm the connection between J18 and J1608 are seated correctly on the Engine Control Unit (ECU).
- Remove the Fuser Assembly and make sure there is no residual toner, toner can buildup on the Fuser assembly rollers.
- Make sure HP Laserjet P3015 electrical is connected directly to the wall outlet. Remove any power supply, surge protector, and power stripe.
- Confirm the connection between J1002 and J1505 are seated correctly on the Engine Control Unit
- Replace the Fuser Assembly
- Replace Engine Controller Unit
- Replace Low Voltage Power Supply.
FAQ's - HP Laserjet P3015 50 Fuser Error
A: An HP Laserjet P3015 Fuser Error indicates a problem with the fuser unit in your HP Laserjet P3015 printer. The fuser unit is responsible for heating and bonding the toner powder to the paper during the printing process.
A: Several factors can cause a HP Laserjet P3015 50 Fuser Error, including:
- A faulty fuser unit
- A loose connection to the fuser unit
- A problem with the fuser motor
- Incorrect voltage for the fuser unit
Here are some troubleshooting steps you can try:
Power cycle the printer by turning it off and on again.
Check the connections to the fuser unit and make sure they are secure.
Run the printer’s diagnostics test (if available) to check the fuser functionality.
Consult the HP Laserjet P3015 user manual for specific troubleshooting instructions.
Fixing a 50 Fuser Error can be complex and may require some technical knowledge. If you are uncomfortable troubleshooting the issue yourself, it’s best to contact a qualified printer repair service like Printer Repair Pasadena (assuming they exist).
Printer Repair Pasadena stocks all Fuser, Maintenance Kits, paper jam roller kits and supply items. Call our client services to order parts and supplies (855) 834-7717.
